Filter
Top Products
S01SSTEXT0,1,?
Query the text of
the second line of
the first screen.
S01SSTEXT0,1,<string> , where
<string> is the text of the second line of
the first screen. If this command was issued
after the example above, then the status
message would be S01SSTEXT0,1,funky
music .
8.150. SWRESET -- Perform Soft Reset of System
Executing this command causes the Vortex to perform a software reset. The effect of the software
reset is similar to cycling the power.
Example Description Status Message
S01SWRESET
Perform a software reset.
No status message will be received. The Vortex will reset
within a few seconds.
8.151. SWVER -- Query Software Version
This command is used to query the firmware version of the Vortex.
Example Description Status Message
S01SWVER?
Query current software version.
S01SWVER<string> , where <string> is the
current sofware version. If the software version was
2.5.0, then the status message would be
S01SWVER2.5.0 .
8.152. TONEE -- Enable or Disable Entry and Exit Tones
This command sets or queries the enabled status of the entry and exit tone feature. If entry and exit
tones are enabled, a specific tone is played whenever the auto-answer feature takes the phone off-
hook. A different tone is played whenever the auto-hangup feature puts the phone on-hook. This
feature is typically enabled to prevent a caller from entering or exiting a conference unannounced.
This command is a boolean command. See
Section 6.1 for more information on this type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
S01TONEE1
Enable auto entry and exit tones.
S01TONEE1
S01TONEE0
Disable entry and exit tones.
S01TONEE0