Filter
Top Products
off-hook or busy tones and hangs up the phone if they are detected. The loop drop method looks for
a drop in loop current on the phone line and hangs up the phone if a loop current drop is detected.
The
AHCP command controls the call progress auto hangup feature. The AHLD command controls the
loop drop auto hangup feature. These two features are controlled and implemented independently.
This command is a boolean command. See
Section 6.1 for more information on this type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
S01AHLD1
Enable loop drop based auto hangup mode.
S01AHLD1
S01AHLD0
Disable loop drop based auto hangup mode.
S01AHLD0
S01AHLD2
Toggle loop drop based auto hangup mode.
S01AHLDx , where x is 0 or 1 depending
on the current state of the loop drop based
auto hangup mode.
S01AHLD?
Query auto hangup mode.
S01AHLDx , where x is 0 or 1 depending
on the current state of the loop drop based
auto hangup mode.
8.11. AMASGN -- Assign Inputs to an Automixer
This command is used to assign the mic/line inputs (1) to an internal automixers. Setting AMASGN to 0
for a given input channel corresponds to no automixer, and 1 corresponds to Automixer #1 .
Although this command is a channel integer command, the increment and decrement operators (>
and <) are not supported for this particular command.
This command is a channel integer command. See
Section 6.3 and Section 6.2 for more information
on this type of command. The minimum and maximum values for this command are 0 and 2,
respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
S01AMASGN11
Assign input 1 to automixer #1.
S01AMASGN11
S01AMASGN1?
Query current automixer assignment
for channel 1.
S01AMASGN1x , where x is 0, 1, or 2
depending on the current automixer
assignment for channel 1. If this command
is issued after the example above, then the
status message will be S01AMASGN11 .