Filter
Top Products
This command sets the gain of the dial tone received from the phone interface.
This command is an integer command. See
Section 6.2 for more information on this type of
command. The minimum and maximum values for this command are -20 and 20, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
S01GAINDT6
Set dial tone gain to 6 dB.
S01GAINDT6
S01GAINDT>3
Increase dial tone gain by 3 dB.
S01GAINDTx , where x is the new value of the dial
tone gain. If this command was issued after the
example above, then the status message would be
S01GAINDT9 .
S01GAINDT?
Query dial tone gain.
S01GAINDTx , where x is the new value of the dial
tone gain. If this command was issued after the
example above, then the status message would be
S01GAINDT9 .
8.57. GAINGIL -- Set Gain of Line Inputs as a Group
This command sets the gains of all the line inputs simultaneously. This is different from using a
wildcard, * with the
GAINI command because that command sets all the mic and line inputs together,
while the GAINGIL sets only the line inputs.
This command will generate acknowledgements from each of the line inputs separately.
This command is an integer command. See
Section 6.2 for more information on this type of
command. The minimum and maximum values for this command are 0 and 20, respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
S01GAINGIL7
Set gain of all line inputs to 7 dB.
S01GAINIA7
S01GAINIB7