Filter
Top Products
Example Description Status Message
S01MINISTRATF1E0&B1S0=2
Set modem initialization
string to
ATF1E0&B1S0=2.
S01MINISTRATF1E0&B1S0=2
S01MINISTR?
Query current modem
initialization string.
S01MINISTR<string> , where
<string> is the current modem
initialization string. If this command was
sent after the above example, then the
status message would be
S01MINISTRATF1E0&B1S0=2 .
8.105. MMUTE -- Mute Crosspoint in Main Matrix or
Submatrix
This command sets or queries the mute status of one or more crosspoints in either the main matrix or
one of the EF Bus submatrices.
This command is a matrix boolean command. See
Section 6.4 and Section 6.1 for more information on
this type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
S01MMUTEB,R1,1
Mute signal path (in
main matrix) from
input B to AEC
reference 1 .
S01MMUTEB,R1,1
S01MMUTEWB0,WM0,0
Mute signal path (in
EF Bus W submatrix)
from W bus signal at
device ID0 (WB0) to
W submatrix output
0 (WM0).
S01MMUTEWB0,WM0,0
S01MMUTE1,B,2
Toggle mute status
of signal path (in
main matrix) from
input 1 to output B .
S01MMUTE1,B,x , where x is either 0 or 1
depending on the current mute status of the
crosspoint.
S01MMUTEA,W,?
Query mute status
of signal path (in
main matrix) from
input A to W-Bus
output .
S01MMUTEA,W,x , where x is either 0 or 1
depending on the current mute status of the
crosspoint.