Filter
Top Products
status of all the microphone inputs. On the EF2211 and EF2210, there is only one microphone, so the
wildcard character is of limited use.
The
GATEEN can be used to have gating information sent automatically instead of having to poll this
command.
Also see the
CGATE command, which only reports microphones that have been gated on for a
specified hold time.
Example Description Status Message
S01GATE1?
Query gating status of microphone input 1.
S01GATE1? , where x is 0 or 1 depending
on whether the input is gated off or gated
on, respectively.
8.64. GATEEN -- Enable Automatic Gating Messages
This command controls whether or not gating information messages are sent automatically. If
GATEEN is enabled, then a GATE*? query is performed each time the gating status of any microphone
changes. For example, if no microphones are currently gated on and GATEEN is enabled, then if
microphone input 1 gates on, the following status message will be automatically generated:
S01GATE*1
See the
GATE command for more information.
This command is a boolean command. See
Section 6.1 for more information on this type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command
will be restored after power-up only if a preset is saved and that preset is set to be the power-on
preset.
Example Description Status Message
S01GATEEN0
Disable automatic gating messages.
S01GATEEN0
S01GATEEN1
Enable automatic gating messages.
S01GATEEN1
S01GATEEN2
Toggle enabled state of automatic gating
messages.
S01GATEENx , where x is either 0 or 1
depending on whether automatic gating
messages are currently disabled or
enabled.
S01GATEEN?
Query enabled state of automatic gating
messages.
S01GATEENx , where x is either 0 or 1
depending on whether automatic gating
messages are currently disabled or
enabled.
8.65. GMUTEO -- Mute All Outputs