Filter
Top Products
System description
20221495F 13
1.8 Optional equipment
A series of optional equipment are available for the basic AP25
system.
R3000X Remote Control
A small handheld remote control with two push buttons for
power steering or course selection (port and starboard), and one
push button with built-in lighted indicator for limited mode
change.
JS10 Joystick
The JS10 Joystick is a Non-Follow-Up steering lever designed
for indoor and outdoor console mount. It has a spring-loaded
return-to-mid-position feature and is equipped with 10 m (33’) of
cable and installation hardware.
FU25 Follow-Up Steering Lever
Note ! Not applicable for Virtual feedback configuration (page 66).
The FU25 Follow-up steering lever features a dial with 5° rudder
angle markings. The rudder will move and stop at the angle
selected on the dial. The FU25 has a mid-position indent, buttons
for (limited) mode selection, and mode indicators. It is designed
for indoor and outdoor bulkhead or flush panel-mounting.
Refer to the FU25 manual for more information.
TI25 Thruster Interface
The TI25 Thruster Interface is designed to provide a control
signal for operating a thruster interfaced to an AP25 system. It
operates on/off solenoids, or a Danfoss PVEM valve. The
Danfoss valve is a proportional valve that will provide full
thruster performance with the output from TI25. The thruster
output signal is calculated in the TI25 based on the mode of
operation and the heading information. Set-up is from the control
unit communicated via Robnet2. All settings are stored in the
thruster interface unit.
Refer to the TI25 manual.