Filter
Top Products
Configuration and setup
20221495F 97
Some important points regarding the installation settings:
• When the AP25 is delivered new from the factory AND ANY
TIME AFTER A MASTER RESET OF MEMORIES HAS
BEEN PERFORMED, the installation settings are all reset to
factory preset (default) values. The automatic interface
prompt will appear (see page
95) and a complete setup has to
be made.
• The values that are selected from within the Installation
Settings Menu, are stored in the memory of the AP25 system.
No specific action is required to "SAVE" the selected values.
Once the value is changed, it is stored until the next time the
menu item is selected and changed.
• The Installation Settings are global except for display units
and language, enabling settings to be distributed to all control
units in the system.
• The Seatrial settings are dependent on successful completion
of the Dockside settings.
4.3 Installation Menu
The Installation Menu is presented
on the autopilot display by pressing
and holding the INFO/SETUP
button for 5 seconds.
Note ! The INSTALLATION MENU is different from the USER SETUP
MENU. Refer to the flow diagram on the next page for a
pictorial view of the Installation Menu.
Navigate through the Installation Menu as follows:
• Answer YES to a question by rotating the course knob
clockwise.
• Answer NO to a question or proceed to the next menu item by
pressing the STBD button.
• Return to the previous menu item by pressing the PORT
button.