Filter
Top Products
4-7
Chapter 4: BIOS
Table 4-8. I/O Device Configuration Submenu
Menu Item Description
Serial Port1 Address
This option specifies the base I/O port address and Interrupt Request address of
serial port 1. The options are D
ISABLED, 3F8/IRQ4, 3E8/IRQ4 and 2E8/IRQ3.
Select D
ISABLED to prevent the serial port from accessing any system resources.
When this option is set to D
ISABLED, the serial port physically becomes
unavailable.
Select 3F8/IRQ4 to allow the serial port to use 3F8 as its I/O port address and
IRQ 4 for the interrupt address.
Serial Port2 Address
This option specifies the base I/O port address and Interrupt Request address of
serial port 2. The options are D
ISABLED, 2F8/IRQ3, 3E8/IRQ4 and 2E8/IRQ3.
Select D
ISABLED to prevent the serial port from accessing any system resources.
When this option is set to D
ISABLED, the serial port physically becomes
unavailable.
Select 2F8/IRQ3 to allow the serial port to use 2F8 as its I/O port address and
IRQ 3 for the interrupt address.
Table 4-9. DMI Event Logging Submenu
Menu Item Description
View Event Log Highlight this item and press <ENTER> to view the contents of the event log.
Mark All Events as
Read
Highlight this item and press <ENTER> to mark all events as read.
Clear Event Log
Select Yes and press <E
NTER> to clear all event logs. The options are YES and
N
O to verify.
Table 4-10. Console Redirection Submenu
Menu Item Description
Remote Access
Allows you to E
NABLE or Disable remote access. If enabled, the settings below
will appear:
Serial Port Number
Selects the serial port to use for console redirection. Options are COM1 and
COM2.
Serial Port Mode
Selects the serial port settings to use. Options are (115200 8, n, 1), (57600 8,
N,
1), (38400 8,
N, 1), (19200 8, N, 1) and (09600 8, N, 1).
Flow Control
Selects the flow control to be used for console redirection. Options are None,
H
ARDWARE and SOFTWARE.
Redirection After
BIOS POST
Options are D
ISABLE (no redirection after BIOS POST), BOOT LOADER
(redirection during POST and during boot loader) and Always (redirection
always active). Note that some OS's may not work with this set to A
LWAYS.
Terminal Type Selects the type of the target terminal. Options are ANSI, VT100 and VT-UTF8.
VT-UTF8 Combo Key
Support
Allows you to Enable or D
ISABLE VT-UTF8 combination key support for ANSI/
VT100 terminals.
Sredir Memory
Display Delay
Use this setting to set the delay in seconds to display memory information.
Options are No Delay, 1
SEC, 2 SECS and 4 SECS.