Filter
Top Products
4
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Stud plates
(as required)
BOTTOM SECTION
INTERMEDIATE I SECTION
Door Section Identification
Door Height Bottom Lock (second) Intermediate (third) Intermediate II (fourth) Top
6’0” 18” 18” 18” NA 18”
6’6” 21” 18” 18” NA 21”
7’0” 21” 21” 21” NA 21”
7’6” 18” 18” 18” 18” 18”
8’0” 21” 18” 18” 18” 21”
When installing your door you must use sections of the appropriate height in
the right stacking order. What sections heights you need to use in what order
depends on the height of your door.
Unless your door is five sections in height, you will not receive an Intermediate
II section.
The BOTTOM SECTION can be identified by the factory attached bottom
astragal, or by the bottom bracket warning labels on each end stile.
The INTERMEDIATE I SECTION may have a warning label attached to either
right or left hand endstile of the section. This section is always the 3rd section
from the bottom of the door.
18” Or 21”
ASTRAGAL
WARNING LABEL
BOTTOM BRACKET
WARNING LABELS
5/16” x 2” tamper-resistant Hex Head Lag
Screws (as required)
(2) 1/4”- 20 Hex
nuts
1/4”- 20 Flange hex nuts
(as required)
(2) 3/8”- 16
Hex nuts
(2) 1/4” x 2- 1/2” carriage bolts
Package Contents Continued...
(2) 1/4” x 2-3/4” carriage bolts
5/16”- 18 Hex nuts
(as required)
1/4”- 20 x 9/16” track Bolts
(as required)
5/16” x 1 5/8” Hex head lag screws
(as required)
5/16” x 1 5/8” tamper resistant Lag Screw
(as required)
(2) 3/8” - 16 x 3/4”
Truss head bolts
1/4” - 14 x 7/8” Self drilling
screws (as required)
(2) 1/4”- 20 X 5/8” Tamper
resistant screws
(2) 3/8”- 16 x 1-1/2” hex Head
Bolts
Clevis pins
(as required)
Cotter pins
(as required)
5/16” Washers
(as required)