Filter
Top Products
5
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
PRE-INSTALLATIONPRE-INSTALLATION
Tools Required
Safety glasses
Flat tip screwdriver
1/4”, 3/8”, 7/16”, 1/2” &
9/16” Wrenches
7/16”, 1/2” & 9/16”
Socket
Phillips head screw-
driver
Ratchet wrench
Power drill
Sawhorse
Gloves
3/8”, 7/16” Socket driver
Hammer
Vice grips
Step ladder
Tape measureLevel Vice clamps
Pencil
9/32”, 1/2”, 3/16” & 1/8” Drill
bits
Approved winding bars
1/4” Torx bit
Removing An Old Door
IMPORTANT: COUNTERBALANCE SPRING TENSION MUST ALWAYS BE RELEASED BEFORE ANY ATTEMPT IS MADE TO START REMOVING AN EXISTING DOOR.
A POWERFUL SPRING RELEASING ITS ENERGY SUDDENLY CAN CAUSE SEVERE OR FATAL INJURY. TO AVOID INJURY HAVE A TRAINED DOOR SYSTEMS TECHNICIAN, USING
PROPER TOOLS AND INSTRUCTIONS, RELEASE THE SPRING TENSION.
For detailed information see supplemental instructions “Removing an Existing Door /Preparing the Opening”. These instructions are available at no charge from Wayne-
Dalton, a Division of Overhead Door Corporation, P.O. Box 67, Mt. hope, Oh 44660, or at www.Wayne-Dalton.com.
WARNING