Filter
Top Products
30 Freedom HF Installation Guide
Basic Installation Procedures
Testing in Shore Power Mode
To test the Freedom HF in shore power mode:
◆ With the appliance from the previous test still connected and
operating, connect the shore power source.
The Freedom HF transfers the appliances to shore power. The status
LED on the display panel will change from yellow to a ten-second
flashing yellow and then green.
If the appliance operates, your installation is successful.
NOTE: If the Inverter button on the Freedom HF is turned ON, the
Freedom HF will automatically supply the appliances with inverter power
if the shore power source fails or becomes disconnected.
If the Inverter button on the Freedom HF is turned ON and shore power
voltage is too low (less than 90 volts AC), the unit will transfer to inverter
power to continue running your appliances.
NOTE: Whether or not the Inverter button is turned ON, shore power will
pass through the Freedom HF to the output when shore power is within
normal operating range
Freedom HF Install Guide.book Page 30 Thursday, November 24, 2011 11:06 AM