Filter
Top Products
3.4.2 Digital Input and Output
HERMES DXD has DVI interfaces. Depending on the type of graphical card and/or the type of projection
module, the following kind of cables are required: DVI-to-DVI, DVI-to-PanelLink, PanelLink-to-DVI.
The DVI-DVI cable is available as copper cable (length up to 10m) and fibre cable (length up to 100m).
The DVI-to-PanelLink and the PanelLink-to-DVI adapter are exclusively available as copper cables.
There are no visible differences between these two adapter. To know which is which, please have a look
at the identification label on the adapter and look up the product number in the table below:
Identification
label
Type of adapter
RSCBL3203x PanelLink out to DVI in
RSCBL3205x DVI out to PanelLink in
Plug in the cables from the two graphic channels into DIGITAL IN 1 and DIGITAL IN 2 and the cables
connecting H
ERMES DXD to the digital projection units into DIGITAL OUT 1, DIGITAL OUT 2.
Figure 3-5
PanelLink-to-DVI-adapter
Figure 3-6
Digital In, DVI interface
Figure 3-7
Digital Out, DVI interface
3.4.3 Remote Control
Plug in the remote control cable coming from the previous device into Remote In and the cable leading
to the next device into
Remote Out. (If there are more than 20 devices a distribution panel must be used)
(see
4.1 Cabling).
Figure 3-8
Remote Control Cabling