Filter
Top Products
Original message is sent back to the RCM
Description: Via this answer the RCM recognizes that the desired RCS cannot be addressed (might be it
has been switched off…)
Example: The
RCM has sent the following command:
Message
<STX> <TYPE> <ADDRH> <ADDRL> <Body> <STATH> <STATL <CHKH> <CHKL> <ETX>
m0 2 t 43
The second
RCS cannot be addressed, and via the closed remote control ring the original
command is passed to
RCM again.
Answer
<STX> <TYPE> <ADDRH> <ADDRL> <Body> <STATH> <STATL <CHKH> <CHKL> <ETX>
m0 2 t 43
If the internal logic control of a RCS detects an error, the input and output of its re-
mote control interface are short-circuited, such that all other remote control devices
can still be addressed. Pay attention that during the addressing procedure all
RCS are
active, in order to prevent confusion in the addresses.