Filter
Top Products
3.5 Operating Hermes DXD
After the cabling is done, you can switch on your system. In order to provide the graphic cards with the
correct timing, it is mandatory that H
ERMES DXD is switched on before booting the controller!
The projection engines can be switched on or off: the timing information is received via the data cable
as soon as the connection is established.
Controlling
HERMES DXD is done via RS232 Remote-Control. Either the commands are sent via a dedi-
cated protocol (RFTP = Remote File Transfer Protocol), or via the graphical user interface of H
ERMES
REMOTE CONTROL, a software tool to intuitively switch the required input to the desired output.
The graphical user interface is described in the user manual HERMES REMOTE CONTROL.
In this manual, the open protocol is explained.