Filter
Top Products
Command “k”: Disabling auto switch
Description: Via this command the RCM tells the RCS of class m to disable auto switch
The
RCS executes the command and sends the acknowledge which informs via the status
register about the auto switch status.
Example: The command
k is sent to the second RCS:
Message
<STX> <TYPE> <ADDRH> <ADDRL> <Body> <STATH> <STATL <CHKH> <CHKL> <ETX>
m0 2 k 3a
case 1: auto switch was already disabled: nothing changes
case 2: auto switch has been enabled before and is now disabled
Since this command only affects the auto switch, the status of the inputs and outputs does
not matter and are assumed 1. The assumptions are written in italic. Then the status re-
gister looks like this:
Status Auto Switch Out2
true
Out1
true
Reserved Out2
target
Out1
target
Prsnt2 Prsnt1
0110 1111
In both cases the acknowledge sent from the RCS to the RCM is the same:
Acknowledge
<STX> <TYPE> <ADDRH> <ADDRL> <Body> <STATH> <STATL <CHKH> <CHKL> <ETX>
m0 2 k 6fd6
Result: auto switch functionality is disabled.