Filter
Top Products
D9112 Operation & Installation Manual
Page 13
© 1993 Radionics
74-06144-000-C 2/96
Installation
Before You Begin
This
Installation
section contains a general installation procedure. It refers you to other
sections of the manual for detailed instructions.
Radionics recommends you review this manual and the
D9112 Program Entry Guide
(74-06145-000) before you begin the installation to determine the hardware and wiring
requirements for the features you want to use.
Have the following additional documents handy as you read through this manual:
•
D9112 Program Record Training Sheet
(74-06447-000)
•
Security System Owner’s Manual
(71-06633-000)
•
D1255 Command Center Installation Manual
(74-06819-000)
Before you begin the installation of the D9112 you should be familiar with the operation of
the D5200 programmer or the RAM II remote programmer.
Enclosure Options
Mount the D9112 Control/Communicator assembly in any of the Radionics enclosures
listed below. Refer to the
Installation Guide for UL and Fire Applications
in this manual to
determine if your application requires a specific enclosure.
• D8103 Universal Enclosure (gray)
• D8109 Fire Enclosure (red)
• D8108A Attack Resistant Enclosure (gray)
Beginning the Installation
Mounting the Enclosure
Mount the enclosure in the desired location. Be certain to use all five mounting holes. See
Figure 2.
POINT CHART LABEL
MOUNTING
SKIRT HOOK
MODULE MOUNTING
LOCATIONS
TAMPER SWITCH
MOUNTING LOCATION
MOUNTING
SKIRT HOOK
MODULE
MOUNTING
LOCATIONS
SKIRT MOUNTING HOLE
HOOK OPENINGS
LOCK-DOWN TAB
BACK OF D9112
Figure 2: Enclosure Mounting