Filter
Top Products
Removing The Power Supply Bay
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Open the system.
3. As applicable, remove the AC or DC power supply and power supply blanks from the power supply bay.
4. Remove the storage controller card (applicable for the left power supply bay).
5. If applicable, remove the optional riser 2 and 3.
6. Press the spring latch (with your index finger and thumb) on top of the power supply bay and pull the bay away from
the chassis side wall.
7. Pull the power supply bay, so that the PDB is disconnected from the connector on the system board.
Follow the same procedure for the removal of other power supply bay in the system.
Figure 51. Removing and Installing the Power Supply Bay
1.
PDB connector on the system board 2. PDB
97