Filter
Top Products
1
Installing PowerPath 4.0
1-9
Installing PowerPath
11. The screen displays information about the installation, ending
with:
----------------------------------------------------
* EMCpower installation:
*
* Installation is successful.
*
* If you have a license key card, register now. Then
* REBOOT the host to complete the remaining steps of the
* installation. Refer to the PowerPath for UNIX
* Installation and Administration Guide for more
* information.
------------------------------------------------------
Installation of <EMCpower> was successful.
The following packages are available:
1 EMCpower EMC PowerPath
(all) 4.0.0_bxxx
2 EMCvg EMC Enterprise Cluster PowerPath Volume
Manager VCS Agent
(sparc) 1.0
Select package(s) you wish to process (or 'all' to
process all packages). (default: all) [?,??,q]:
• If you are installing PowerPath for a VCS cluster and you
want to install the PowerPath Volume Manager VCS Agent
now, enter
2 and press ENTER. Continue with Install the VCS
Agent Software, step 5, on page 1-22.
• Otherwise, enter
q and press ENTER.
PowerPath is now installed on the host. You must register
PowerPath, reboot the host, and perform other administrative tasks
before PowerPath can run on the host. Refer to After You Install on
page 1-16 for postinstallation information and procedures.