Filter
Top Products
1
After You Install
1-17
Installing PowerPath
3. Enter the PowerPath registration key and press ENTER.
If you entered a valid key, you see the following output:
1 key(s) successfully added.
Key successfully installed.
Key (Enter if done):
4. Press ENTER. You see the following output:
1 key(s) successfully registered.
Registering PowerPath after you install the software and before you reboot
the host sets the appropriate default load balancing and failover policy. If you
reboot the host before you register PowerPath, you must run the
powermt set policy to reset the load balancing and failover policy. Refer
to the PowerPath Product Guide or the powermt(1) man page for more
information on powermt set policy.
Remove the
CD-ROM
1. If the CD-ROM volume management daemon vold is running,
unmount and eject the CD-ROM. Enter:
eject
and remove it from the drive.
2. If
vold is not running, unmount the CD-ROM. For example,
enter:
umount /cdrom/cdrom0
and, after the CD-ROM unmounts, eject it and remove it from the
drive.
Reboot the Host
Reboot the host. Enter:
reboot -- -r
Registering PowerPath after you install the software and before you reboot
the host sets the appropriate default load balancing and failover policy. (Refer
to Register PowerPath on the Host on page 1-16.) If you reboot the host before
you register PowerPath, you must run the powermt set policy to reset the
load balancing and failover policy. Refer to the PowerPath Product Guide or the
powermt(1) man page for more information on powermt set policy.