A SERVICE OF

logo

1. INSTALLATION
1-12
2. Set the spacer (3) to the place selected at paragraph 1.4.1.
The “FORE-AFT” line on the spacer must be parallel with the ship's fore and aft line (within
3°). For horizontal direction, the bottom of the spacer must be parallel with the ship's
draft.
3. Weld the spacer (3) to the ship's hull. The welding and doubling methods are left up to the
shipyard.
4. Unfasten M12 hex. nut (20), spring washer (21) and flat washer (22) to remove the shaft (6)
from the seachest cap (4).
5. Paint the gate valve (2), spacer (3) and seachest cap (4) the same color as ship's body. Paint
only gray-colored areas; for other part, seal with a masking tape.
6. Pass the cable from the transducer (1) through the shaft (6) from the bottom.
7. Apply liquid gasket (supplied) on the top of the transducer (1).
8. Use hex. bolt (26) and seal washer (27) to fasten the transducer (1) to the shaft (6).
-M12 hex. nut (20)
-M12 spring washer (21)
-M12 flat washer (22)
Seachest cap (4)
Shaft (6)