Filter
Top Products
2-5
2.2 Processor Unit
Two cables are terminated at the processor unit: the signal cable S03-75 and the power cable.
The signal cable comes with a connector preattached to it for connection to the processor unit.
Fabricate the power cable as below.
2.2.1 Fabricating the AC power cable
1. Remove the vinyl sheath by 80 mm. Cut off jute tape wrapped around the armor. Unravel
the armor to expose the cores by about 35 mm.
2. Remove insulation of cores by about 10 mm. Fix crimp-on lugs to the cores and armor.
3. Cover the armor with vinyl tape, leaving the portion which will lie inside the cable clamp
untaped.
40 mm
Clamp here.
Taping
(a)
(b)
(d)
Vinyl sheath
5 mm
Armor
DPYCY-3.5
10 mm
(c)
Approx. 80 mm
Core
S = 3.5 mm
φ = 2.4 mm
2
Armor
Vinyl sheath
(sectional view)
Figure 2-8 Fabricating power cable DPYCY-3.5