Filter
Top Products
25
5
BASIC OPERATION
■ Selecting output power
The transceiver has 4 output power levels to suit your operat-
ing requirements. Low output powers during short-distance
communications may reduce the possibility of interference to
other stations and will reduce current consumption.
➥Push the desired band’s [
(MONI)LOW] for 2 sec. one or
more times to select the output power.
•Push [CHG/L] if [MONI(LOW)] is not displayed.
•The output power can be changed while transmitting.
The microphone can also be used to select output power.
q Push [BAND] to select the desired band.
w Push [rHIGH] for high output power; [tMID]
for mid-high output power; and [yLOW] for low
output power.
•The output power CANNOT be changed via the mi-
crophone while transmitting.
■ One-touch PTT function
The PTT switch can be operated as a one-touch PTT switch
(each push toggles transmit/receive). Using this function you
can transmit without pushing and holding the PTT switch.
To prevent accidental, continuous transmissions with this
function, the transceiver has a time-out timer. See p. 63 for
details.
q Push [FUNC] then [ePTT-M] to turn the one-
touch PTT function ON.
•The activity indicator lights green.
w Push [PTT] to transmit and push again to re-
ceive.
•Two beeps sound when transmission is started and
a long beep sounds when returning to receive.
•“TX” flashes when transmitting with the one-touch
PTT function.
e Push [FUNC] then [ePTT-M] to turn the one-
touch PTT function OFF.
•The activity indicator goes out.
Power
selection
S/RF indicator
Output power Taiwan
version only
LOW
MID LOW
MID HIGH
HIGH
05 W
10 W
20 W
50 W
05 W
10 W
20 W
35 W
05 W
10 W
15 W
25 W
TX
LO
TX
MID-LO
TX
MID-HI
TX
HI
VHF UHF
HIGH
4
MID
5
LOW
6
PTT-M
B