Filter
Top Products
62
14
WIRELESS OPERATION
■ Microphone address
The transceiver has 8 possible microphone addresses (in-
cluding OFF) to help prevent interference from other HM-90
wireless microphones. Set both the microphone address and
microphone dip switch to the same value as follows.
When the supplied microphone is connected, the trans-
ceiver rejects control signals from the HM-90 even when
the microphone address is matched.
DMicrophone address
q Push [(DISP)SET] for 2 sec. to enter set mode.
•Push [CHG/L] if [(DISP)SET] is not displayed.
w Push [Y] or [Z] to select the ‘HM-90 Address’ item.
•Left-hand tuning dial can also select the item.
e Rotate the right-hand tuning dial to set the microphone ad-
dress to 0–7 or to turn the microphone control OFF.
•When “OFF” is selected, the
transceiver rejects all control sig-
nals from the HM-90.
r Push [ï] to exit set mode.
q Push [FSET]; then push [FSET] or [GENT] to
select the ‘HM-90 Address’ item.
w Push [Y] or [Z] to set the microphone address
to 0–7 or to turn the microphone control OFF.
e Push [ECLR] to exit set mode.
DMicrophone dip switch
q Remove the switch cover from the microphone rear panel.
w Set the microphone dip switch and the microphone ad-
dress to the same value as shown below.
e Replace the switch cover.
MICROPHONE DIP SWITCH
ADDRESS S1-1 S1-2 S1-3
0 OFF OFF OFF
1 (default) ON OFF OFF
2 OFF ON OFF
3ONONOFF
4 OFF OFF ON
5 ON OFF ON
6 OFF ON ON
7ONONON
LOCK
AFC AFC-OFF PTT-M MW
PGR
CALL
123A
456B
MR VFO CLR
C-SQL DTMF D-OFF
HIGH MID LOW SET
Switch cover
Dip switch (S1)
ON
OFF
123
ï
Y
Z
SET
Squelch Delay
Long
1
HM-90 Address
Sub Band Mute
SET
B