33
7
MEMORY/CALL CHANNELS
■ Programming after selection
q Select memory mode with the desired band’s [M/C].
•Push [CHG/L] if [M/C] is not displayed.
•“!” appears when memory mode is selected.
w Set the memory channel to be programmed with the de-
sired band’s tuning dial.
e Push [V/M
H
] to select VFO mode.
r Set the desired frequency:
➥Set the frequency using the desired band’s tuning dial.
➥Set other data (e.g. offset frequency, duplex direction,
subaudible tone frequency, etc.), if required.
t Push [
(S.MW)MW] for 2 sec. to program into the selected
channel.
•Push [CHG/L] if [(S.MW)MW] is not displayed.
•Memory channel number automatically advances when continu-
ing to push [MW] after programming.
■ Transferring memory
contents to another memory
q Select memory mode with the desired band’s [M/C].
•Push [CHG/L] if [M/C] is not displayed.
•“!” appears when memory mode is selected.
w Set the desired memory channel with the desired band’s
tuning dial.
e Push the desired band’s [S.MW] momentarily to indicate
memory channels.
•Push [CHG/L] if [S.MW] is not displayed.
•Push [S.MW] for 2 sec.to transfer the memory channel contents
to VFO.
r Rotate the tuning dial to select the desired channel.
•Call channel (C), VFO (- -) and scan edges (1A – 3B), as well as
regular memory channels, can be transferred in this way.
t Push [(S.MW)MW] for 2 sec. to transfer.
