65
15
OTHER FUNCTIONS
■ Squelch delay
During operation, received signal strength often fluctuates.
This can result in annoying repeated opening and closing of
the squelch during reception of the same signal. The trans-
ceiver has a built-in squelch delay function which helps pre-
vent this. When both stations are operating from a fixed
location e.g. during packet operation, this function should be
set to “short.”
q Push [
(DISP)SET] for 2 sec. to enter set mode.
•Push [CHG/L] if [(DISP)SET] is not displayed.
w Push [Y] or [Z] to select the ‘Squelch Delay’ item.
•Left-hand tuning dial can also
select the item.
e Rotate the right-hand tuning
dial to set the squelch delay
to “Long” or “Short.”
r Push [ï] to exit set mode.
q Push [FSET] to enter set mode.
w Push [FSET] or [GENT] to select the ‘Squelch
Delay’ item.
e Push [Y] or [Z] to set the squelch delay to
“Long” or “Short.”
r Push [ECLR] to exit set mode.
■ Sub band mute
The sub band mute function automatically cuts out sub band
AF signals when a main band signal is received.
“ ” appears while the sub band mute is activated.
q Push [
(DISP)SET] for 2 sec. to enter set mode.
•Push [CHG/L] if [(DISP)SET] is not displayed.
w Push [Y] or [Z] to select the ‘Sub Band Mute’ item.
•Left-hand tuning dial can also
select the item.
e Rotate the right-hand tuning
dial to turn the sub band
mute function ON or OFF.
r Push [ï] to exit set mode.
q Push [FSET] to enter set mode.
w Push [FSET] or [G ENT] to select the ‘Sub
Band Mute’ item.
e Push [Y] or [Z] to turn the sub band mute
function ON or OFF.
r Push [ECLR] to exit set mode.