Filter
Top Products
75
15
OTHER FUNCTIONS
■ Partial reset
If you want to initialize the operating conditions (VFO fre-
quency, VFO settings, set mode contents) without clearing the
memory contents, a partial resetting function is available for
the transceiver.
Band conditions can be reset independently.
DVHF band partial resetting
➥While pushing the 2nd switch from the top on the left side,
turn power ON to partially reset the transceiver.
•“144M VFO Clear” appears when resetting the VHF band condi-
tion.
DUHF band partial resetting
➥While pushing the 2nd switch from the top on the right side,
turn power ON to partially reset the transceiver.
•“430M (440M) VFO Clear”appears when resetting the UHF band
condition.
DPartial resetting of both bands
➥While pushing the 2nd switches from the top on both the
left and right sides, turn power ON to partially reset the
transceiver.
•“VFO Clear” appears when resetting the VHF and UHF band
condition.
■ All reset
The function display may occasionally display erroneous in-
formation (e.g. when first applying power). This may be
caused externally by static electricity or by other factors.
If this problem occurs, turn power OFF. After waiting a few
seconds, turn power ON again. If the problem persists, per-
form the following procedure.
•Partial resetting is also available.See previous section for details.
CAUTION: Resetting the transceiver CLEARS all mem-
ory information and initializes all values in the transceiver.
➥While pushing the 3rd switches from the top on both the left
and right sides, turn power ON to reset the CPU.
•“Memory Clear” appears when resetting the CPU.
[POWER]
All reset
UHF partial
reset
VHF partial
reset