45
9
SCAN OPERATION
■ Memory scan
q Select memory mode with the desired band’s [M/C].
•Push [CHG/L] if [M/C] is not displayed.
•“!” appears when memory mode is selected.
w Make sure the squelch is set to the threshold point.
e Push [
(M/C)SCN] for 2 sec. to enter the scan screen.
•If the pocket beep function is activated, the transceiver automat-
ically selects the tone squelch function when the scan screen is
selected.
r Push [MEM] momentarily to start the scan.
•Decimal point and“!” flash while scanning.
•To change the scanning direction, rotate the desired band’s tun-
ing dial.
t To stop the scan, push [MEM] again.
y Push [
(MAIN)í] for 2 sec. to exit the scan screen.
q Select the desired band with [BAND].
w Select memory mode with [MR].
e Push [SQLY] or [SQLZ] to set the squelch to
the threshold point.
r Push [wSCAN] momentarily or [Y]/[Z] for 2
sec. to start memory scan.
•Decimal point and“!”flash while scanning.
t Push [Y], [Z] or [ECLR] to cancel the scan.
At least 2 memory channels must be programmed for
memory scan to start.
