31
6
REPEATER OPERATION
■ Auto repeater function
(U.S.A. and Korea versions only)
The U.S.A. and Korea versions automatically activate the re-
peater settings (duplex ON/OFF, duplex direction, tone en-
coder ON/OFF) when the operating frequency falls within or
outside of the general repeater output frequency range. The
offset and repeater tone frequencies are not changed by the
auto repeater function, reset these frequencies, if necessary.
q Push [
(DISP)SET] for 2 sec. to enter set mode.
•Push [CHG/L] if [(DISP)SET] is not displayed.
w Push [Y] or [Z] to select the ‘Auto Repeater’ item.
•Left-hand tuning dial can also select the item.
e Rotate the right-hand tuning dial to select the auto repeater
function.
U.S.A. version:
•“Dup” Activates duplex only.
•“Dup&Tone” Activates duplex and tone.
•“OFF” Auto repeater function is turned OFF.
Korea version:
•“ON” Activates duplex and tone.
•“OFF” Auto repeater function is turned OFF.
r Push [ï] to exit set mode.
q Push [FSET] to enter set mode.
w Push [FSET] or [GENT] to select the ‘Auto Re-
peater’ item.
e Push [Y] or [Z] to select the auto repeater
function.
r Push [ECLR] to exit set mode.
DFrequency range and offset direction
•U.S.A. version
•Korea version
FREQUENCY RANGE DUPLEX DIRECTION
145.200–145.495 MHz
146.610–146.995 MHz
“DUP–” appears
147.000–147.395 MHz “DUP” appears
442.000–444.995 MHz “DUP” appears
447.000–449.995 MHz “DUP–” appears
