Filter
Top Products
106
8
MEMORY OPERATION
8
Select memory channels are used for select memory
scan. Select memory scan repeatedly scans the se-
lect memory channels only. This is useful to speed up
the memory scan interval. Of course, select memory
channels are also scanned during normal memory
scan.
qSelect the memory channel list as described at left.
wPush [PBT/M-ch/RIT] momentarily to select the M-
ch/RIT function, if the twin PBT is selected.
•[PBT/M-ch/RIT] indicator (Green) goes out.
eRotate [M-ch] (inner) control to select the desired
memory channel.
•All memory channels including blank channels can be
selected.
•[
Y
]/[
Z
] on the microphone also changes the channels.
rPush [F-1
SEL
] to set the memory channel as a
select memory or not.
tRepeat steps e to r to program another memory
channel as a select memory channel, if desired.
yPush [
Z
(
MENU
/
GRP
)] twice to exit the memory
channel list.
Setting select memory channels is also possible in
the memory scan indication. (p. 115)
“ß” appears for select memory channel.
Push [F-1 SEL]
[MENU/GRP] [F-1]
[PBT/M-ch/RIT] indicator
[PBT/M-ch/RIT] switch/[M-ch] (inner) control
DSetting a memory channel as a select memory
The IC-7000 has a total of 5 memory banks (99 mem-
ory channel each), A to E, are available for usage by
group, etc.
qSelect the memory channel as described at p. 102.
wPush [PBT/M-ch/RIT] momentarily to select the M-
ch/RIT function, if the twin PBT is selected.
•[PBT/M-ch/RIT] indicator (Green) goes out.
eRotate [RIT] (outer) control to select the desired
memory bank.
• Memory channel list indication
qSelect the memory channel list as described at left.
wPush [F-4
BNK
] several times to select the desired
memory bank.
•Rotating [RIT] (outer) control also changes the bank.
ePush [
Z
(
MENU
/
GRP
)] twice to exit the memory
channel list.
Push
Bank indication
BNK
[F-4]
[MENU/GRP]
[RIT] (outer) control
Bank indication
DSelecting a memory bank