Filter
Top Products
3
25
BASIC OPERATION
■ When first applying power (CPU resetting)
Before first applying power, make sure all connec-
tions required for your system are complete by refer-
ring to Chapter 2. Then, reset the transceiver using
the following procedure.
Resetting CLEARS all programmed contents in
memory channels and returns programmed values
in set mode.
qMake sure the transceiver power is OFF.
wWhile pushing [
Y
(
BAND
)] and [
Z
(
BAND
)], push
[PWR] for 1 sec. to start resetting.
•The internal CPU is reset.
•The display changes to ‘ALL CLEAR,’ ‘RF power 100%’
and ‘Initial frequency and Mode’ as shown at right.
The transceiver’s
initial frequency and mode
[PWR]
[Y]
[Z]
[RF/SQL]: Center
[LOCK]: OFF
[POWER]: OFF
[AF]: Max. CCW
[PBT]: Center
(Push and hold for 1 sec.)
[PBT/M-ch/RIT]
: PBT
(indicator lights)
CCW : counterclockwise
DMenu resetting (
M
-
1
)
Turn power ON, then check the display. If any of the
following indicators appear, turn them OFF as follows:
•Tuning step indicators,
Z
, (SSB, CW or RTTY):
Push [TS].
•MHz tuning step indicator,
Z
, (FM, WFM or AM):
Push [TS]
•1 Hz frequency readout (SSB, CW or RTTY):
Push and hold [TS].
•Preamp indicator, :
Push [P.AMP/ATT]
•Attenuator indicator, :
Push [P.AMP/ATT]
•Noise blanker indicator, :
Push [NB/ADJ]
•Noise reduction indicator, :
Push [NR/LEV]
•Manual notch indicator, :
Push [MNF/ADJ]
•Auto notch indicator, :
Push [ANF/
•
REC]
•Memory mode indicator, MEMO:
Use [F-4
V/M
] in the
M
-
2
menu (p. 27).
•Split indicator, :
Use [F-1
SPL
] in the
M
-
1
menu (p. 91).
If you can’t figure out how to return to the menu
M
-
1
:
While pushing either [
Y
(
MENU
/
GRP
)] or [
Z
(
MENU
/
GRP
)], turn power ON.
•The other groups are also reset to
S
-
1
or
G
-
1
(Scope) in
this time.
[PWR]
[MENU/GRP]
After resetting the transceiver, set controls and
switches as shown in the diagram below.
■ Initial settings