Filter
Top Products
Command Module and Drive Module Site Preparation Guide i
Regulatory Compliance Statements
FCC Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the Federal Communications Commission (FCC) Rules. These limits are designed to provide
reasonable protection against harmful interference in a commercial installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case the user will be required to correct the
interference at his own expense.
LSI Logic Corporation is not responsible for any radio or television interference caused by unauthorized
modification of this equipment or the substitution or attachment of connecting cables and equipment other
than those specified by LSI Logic Corporation. It is the user’s responsibility to correct interference caused by
such unauthorized modification, substitution, or attachment.
Laser Products Statement
This equipment has been tested and found to comply with regulations for Class 1 laser product pursuant to
21 CFR, Section 1040-10. For outside the USA, this equipment has been tested and found compliant with
Class 1 laser product requirements contained in European Normalization standard EN 60825-1 1994+A11.
Class 1 levels of laser radiation are not considered to be hazardous and are considered safe based upon
current medical knowledge. This class includes all lasers or laser systems which cannot emit levels of optical
radiation above the exposure limits for the eye under any exposure conditions inherent in the design of the
laser product.
LSI Logic Corporation is not responsible for any damage or injury caused by unauthorized modification of
this equipment or the substitution or attachment of connecting cables and equipment other than those
specified by LSI Logic Corporation. It is the user’s responsibility to correct interference caused by such
unauthorized modification, substitution, or attachment.
This Class A digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
Cet appareil numérique de la classé A respecte toutes les exigences du
Règlement sure le matèriel brouilleur du Canada.