Filter
Top Products
Command Module Site Preparation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-14 Command Module and Drive Module Site Preparation Guide
E4600 and E5600 Command Modules
The E4600 and E5600 command modules support fiber optic connections to both hosts
and drive modules. Up to four host minihubs and four drive minihubs can be installed in a
command module. Each Small Form-factor Pluggable (SFP) minihub has two connectors,
allowing a maximum of sixteen connections. An SFP transceiver (Figure 2-6) attaches to
one end of the fiber optic cable and plugs into the SFP minihub, which is connected to the
command module. The other end of the cable connects to an optical GBIC module in the
drive module.
Figure 2-6 SFP Transceiver and Fiber Optic Cable
Refer to Table 2-9 and Table 2-10 for interface connector cable lengths available from your
local dealer.
Table 2-9 E4600 Command Module Fibre Channel Host and Drive Interface Cables
Descriptions Order Information
Cable Data Rate
Transfer
Speed
Maximum Part Number Length
Fiber optic
50/125UM LC/LC
At least
200 MB/s
At least
2125 Mb/s
.03 kilometer
006-1086713 2 meter
006-1086714 3 meter
006-1086715 5 meter
006-1086716 10 meter
006-1086717 25 meter
006-1086718 50 meter
Fiber optic
50/125UM SC/LC
100 MB/s 1062.5 Mb/s 0.5 kilometer
006-1086723 2 meter
006-1086724 3 meter
006-1086725 5 meter
006-1086726 10 meter
006-1086727 25 meter
006-1086728 50 meter
SFP Transceiver
Fiber Optic Cable