Filter
Top Products
Page 107CPV350
19.6.2 Receiving a Group Call
1. When a group call is received, the CPV350 will produce a ringing
alarm sound.
2. The radio automatically switches to the requested channel, and
appear “RECEIVED DSC CALL” popup window on the display to
see the MMSI of the vessel transmitting the Group Call.
3. Press any key to stop the alarm.
4. Monitor the channel for the person calling the Group for a
message.
5. If you want to respond, monitor the channel to make sure it is clear, then press [PTT]
on the microphone and talk to the calling ship(s).
19.7 POSITION REQUEST
Advancements in DSC have made it possible to poll the location of another vessel and show
the position of that vessel on the display of the CPV350 making it easy to navigate to the
location of the polled vessel. This is a great feature for anyone wanting to know the position
of another vessel. For example your buddy that is catching fish, or finding the location of a
person you are cruising with.
NOTE
The other vessel must have an operating GPS receiver connected to its DSC transceiver and must
not have its transceiver set to deny position requests. (Refer the section “19.4.0 Setting up the
Individual / Position Call Directory” to enter information into the individual directory).
19.7.0 Setting up Position Reply
The CPV350 can be set up to automatically or manually send your position to another
vessel. This selection is important if you are concerned about someone polling the position
of your vessel that you may not want to. In the manual mode you will see the MMSI or
persons name shown on the display allowing you to choose to send your position to the
requesting vessel.
1. Press [MENU] two times. Move the ShuttlePoint knob to highlight
RADIO SETUP and
press [ENT] or move the ShuttlePoint knob to the right.
2. Move the ShuttlePoint knob to highlight
DSC SETTINGS and press [ENT] or move the
ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight
POS REQUEST REPLY and press [ENT] or
move the ShuttlePoint knob to the right.
4. Another popup window will be shown with
Manual or Automatic, move the ShuttlePoint
knob to the desired selection and press [ENT] or move the ShuttlePoint knob to the right.
In
Manual mode, the display of the CPV350 will show who is requesting the position.
In
Automatic mode, after a DSC POS Request is received, the radio will automatically
transmit your vessels position.
5. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left a few times.