Filter
Top Products
Page 95CPV350
19.1.1 Programming the MMSI
WARNING
User MMSI can be input only twice. If the user tries to input an MMSI more than
twice, the radio will show the display on the right. If the user needs to change the
MMSI more than twice, the transceiver will have to be sent to Factory Service. Refer
to the section “23.1 FACTORY SERVICE.”
1. Press [MENU] two times. Move the ShuttlePoint knob to highlight
RADIO SETUP and
press [ENT] or move the ShuttlePoint knob to the right.
2. Move the ShuttlePoint knob to highlight
DSC SETTINGS and press [ENT] or move the
ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight
USER MMSI and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to the up or down to select the first number of your MMSI,
then move the ShuttlePoint knob to the right to step to the next number.
5. Repeat step 6 to set your MMSI (up to nine digits).
6. When finished programming the number, press the [ENT] to store the number in
memory.
7. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left a few times.
Figure 19.1 - DSC SETTINGS menu
19.2 DSC DISTRESS CALL
The CPV350 is capable of transmitting and receiving DSC Distress messages from all DSC
radios. The CPV350 will transmit the Latitude, Longitude of the vessel if the GPS has a fix.
19.2.0 Transmitting a DSC Distress Call
NOTE
To be able to transmit a DSC distress call an MMSI number must be programmed, refer to section
“19.1.1 Programming the MMSI.” In order for your ships location to be transmitted a GPS antenna
must be connected to the CPV350, refer to section “2.3 MOUNTING THE GPS WASS SMART
ANTENNA.”
1. Lift the red spring loaded DISTRESS cover and press [DISTRESS]. “DISTRESS
ALERT” popup window will appear on the display.