Filter
Top Products
Page 111CPV350
Figure 19.8.0 - RINGER OUTPUT menu
19.8.1 Transmitting a DSC Position Send Call
Pre-Programmable Calling
Using the Individual directory to transmit a position send call.
1. Press [CALL]. The “DSC Operation” menu Tabs will appear at the bottom edge of the
display.
2. Press [POSITION SEND] to show “DIRECTORY” popup
window on the display.
3. Move the ShuttlePoint knob to the up or down or turn the
Channel knob to select the “Individual” you want to contact,
then press [ENT].
4. Press [ENT] again to send your position to the selected vessel.
Manual Calling
1. Press [CALL]. The “DSC Operation” menu soft keys appear below the display.
2. Press [POSITION REQUEST] to show “DIRECTORY” popup window on
the display.
3. Move the ShuttlePoint knob to the up or down or turn the Channel knob
to select
MANUAL, then press [ENT] to appear “MMSI INPUT” popup
window on the display.
4. Move the ShuttlePoint knob to up or down to scroll through numbers, 0-
9 to enter the desired number and move the ShuttlePoint knob to the
right to move one space to the right. Repeat this procedure until all
nine space of the MMSI number are entered.
5. If a mistake was made entering in the MMSI number move the
ShuttlePoint knob to the left until the wrong number is selected, then
move the ShuttlePoint knob to up or down to correct the entry.
6. When finished entering the MMSI number, press [ENT].
7. Press [ENT] again to send your position to the selected vessel.