Filter
Top Products
Page 123CPV350
4. Speak slowly and clearly into the microphone, hold the microphone about 1/2 inch away
from your mouth.
5. When finished, release the [PTT] switch.
6. To exit the “INTERCOM” mode and return to radio operation mode, press the [F] key
followed by the [5(IC)] key again.
22.2.1 Calling
Press and hold the [5(IC)] key for 1 second when the “INTERCOM” operation is activated,
a calling beep is emitted from the CPV350 speaker.
22.3 MANUAL INPUTTING OF THE GPS LOCATION (LAT/LON)
You may send the Latitude/Longitude of your vessel manually from the VH-310 Handset
even if the CPV350 is not connected the GPS receiver unit.
After the position is entered, transmitting a DSC Distress, Position Request, or Position
Send will contain the manually entered position.
1. Press and hold down the [CALL(MENU)] key until “Radio Setup” menu
appears.
2. Press the [] key to select “DSC SETUP” menu.
3. Press the [ENT] key, then select “POS INPUT” with the []/[] key.
4. Press the [ENT] key then, enter the your local time from the keypad by
the 24-hour system on the UTC time.
5. Enter the Latitude of your vessel location (xx.xx.xx) by the keypad, then
press the [6(NAV)] key to select North (N), or [7(SCRM)] key to select
South (S).
6. Enter the Longitude of your vessel location (xxx.xx.xx) by the keypad,
then press the [3(SCAN)] to select East (E), or [9(FOG)] key to select
West (W).
7. If a number was entered by mistake, press the [H/L] key repeatedly to
select the number. Press the []/[] key to select the desired number.
8. Press and hold in the [ENT] key to store the data entered, then press the
[16/9] key to exit this menu and return to radio operation mode.