Filter
Top Products
GX5500SPage 20
[
H/L
]
Key
Press the
[
H/L
]
key to toggles between 25 W (High) and 1 W (Low)
power. When the
[
H/L
]
key is pressed while the transceiver is on chan-
nel 13 or 67, the power will temporarily switch from LO to HI power until
the PTT is released. The
[
H/L
]
key does not function on transmit inhib-
ited and low power only channels.
CHANNEL SELECTOR KNOB
Rotary knob used to select channels and to choose menu items (such as
the DSC menu, Radio Setup and DSC Setup menu). The
[
UP
(
S
)]
/
[
DOWN
(
T
)]
keys on the microphone can also be used to select channels
and menu items.
Secondary Use
y Press the
[
F
]
key first then press the
[
3
(
SCAN
)]
key, and turning the
CHANNEL selector knob while holding down the
[
3
(
SCAN
)]
key, you
can confirm memory channels for scanning.
y Adjusts the PA output level while in PA/FOG mode.
KEYPAD
[
1
(
DIM
)]
Key
When in radio mode, this key is used to directly select channel digit “1”
in a channel number.
Secondary use
Press the
[
F
]
key first then press the
[
1
(
DIM
)]
key, access the LCD Dim-
mer menu. Refer to section “10.16 LCD DIMMER” for details.
[
2
(
MEM
)]
Key
When in radio mode, this key is used to directly select channel digit “2”
in a channel number.
Secondary use
Press the
[
F
]
key first then press the
[
2
(
MEM
)]
key, memorize the se-
lected channel into the transceiver scan memory for scanning. When
repeat the same procedures
([
F
]
Æ
[
2
(
MEM
)])
, DELETES the channel
from the scan memory. Refer to section “10.13 SCANNING” for details.
[
3
(
SCAN
)]
Key
When in radio mode, this key is used to directly select channel digit “3”
in a channel number.
Secondary use (Depends on the transceiver version)
Press the
[
F
]
key first then press the
[
3
(
SCAN
)]
key, start and stop the
scanning of programmed channels. Refer to section “10.13 SCANNING”
for details.