Filter
Top Products
Page 75GX5500S
Key, then press the
[
S
]
or
[
T
]
key to the desired listen
back volume.
To exit from the FOG or other signaling mode, press the
[
16/9
]
,
[
WX
]
, or
[
CALL/SET
]
key.
13.4 MANUAL INPUTTING OF THE GPS LOCATION
(
LAT/LON
)
You may send the Latitude/Longitude of your vessel manually from the RAM+
Mic when the GX5500S is not connected the GPS receiver.
After the position is entered, transmitting a DSC Distress, Position Request, or
Position Send will contain the manually entered position.
1. Press and hold down the
[
CALL
(
SET
)
MENU
]
key until “
RA-RA-
RA-RA-
RA-
DIO SETUPDIO SETUP
DIO SETUPDIO SETUP
DIO SETUP” menu appears.
2. Press the
[
T
]
key to select “
DSC SETUPDSC SETUP
DSC SETUPDSC SETUP
DSC SETUP” menu.
3. Press the
[
CALL
(
SET
)
MENU
]
key, then select “
POS INPUTPOS INPUT
POS INPUTPOS INPUT
POS INPUT”
with the
[
S
]
/
[
T
]
key.
4. Press the
[
CALL
(
SET
)
MENU
]
key. The display will be as
shown in the illustration on the right.
5. Enter the your local time by the 24-hour system on the
UTC time. Use the
[
CALL
(
SET
)
MENU
]
and
[
H/L
]
key to
navigate to each column of the time, then use the
[
S
]
/
[
T
]
key to select the desired numbers in each column. Repeat
for each column, to complete the time.
6. Enter the Latitude/Longitude of your vessel location with
the same procedure as description above.
7. To store the data entered, press the
[
16/9
]
key to exit this
menu and return to radio operation mode.