Filter
Top Products
Page 45GX5500S
7. When an individual call acknowledgment is re-
ceived, the established channel is automatically
changed to the channel which is selected on
step 5 above and a ringing tone sounds.
8. Press
[
CLR
]
key to listen to the channel to make
sure it is not busy, then key the microphone
and call the other vessel you desire to com-
municate with.
Manual Calling
You may enter an MMSI number manually to contact without storing it in the
Individual Directory.
1. Press the
[
CALL
(
MENU
)]
key. The “
DSC Op-DSC Op-
DSC Op-DSC Op-
DSC Op-
erationeration
erationeration
eration” menu will appear.
2. Turn the CHANNEL selector knob to select “
In-In-
In-In-
In-
dividualdividual
dividualdividual
dividual.” (To cancel, press the
[
CLR
]
key.)
3. Press the
[
ENT
]
key. The transceiver will beep,
and the “Individual directory” will appear.
4. Turn the CHANNEL selector knob to select
“
ManualManual
ManualManual
Manual,” then press the
[
ENT
]
key.
5. Enter the MMSI number (nine digits) which you want
to contact by the keypad, then press the
[
ENT
]
key.
6. If a mistake was made entering in the MMSI num-
ber repeat pressing the
[
H/L
]
key until the wrong
number is selected, then enter the correct number.
7. When finished entering the MMSI number, press and
hold the
[
ENT
]
key.
8. Turn the CHANNEL selector knob to select
“
ManualManual
ManualManual
Manual,” then press the
[
ENT
]
key.
9. Turn the CHANNEL selector knob to select the
operating channel you want to communicate on and
press the
[
ENT
]
key.
10. Press the
[
ENT
]
key again to transmit the indi-
vidual DSC signal.
11. When an individual call acknowledgment is re-
ceived, the established channel is automatically
changed to the channel which is selected on
step 5 above and a ringing tone sounds.
12. Press the
[
CLR
]
key to listen to the channel to
make sure it is not busy, then key the micro-
phone and call the other vessel you desire to communicate with.