Filter
Top Products
E6581429
C-3
3
3.3 Operation in Top View Mode
When the inverter is powered on, it enters this mode first, which allows you to monitor the operating status, set an
operation frequency, use EASY key, and switch between languages.
When Panel Jog Run is selected, a jog run frequency also can be specified in this mode.
Q Explanation of the top window
• Display of commands executed:
“FWD” or “REV” is displayed to indicate the direction of rotation.
The operation frequency is displayed in the form of “. Hz”.
• Display of operating status:
“RUN” is displayed during operation.
“STOP” is displayed during a stop.
“Trip” is displayed in the event of tripping.
• Display of output frequency:
The operation frequency is displayed in the form of “. Hz”.
• Display of alarm/trip:
In case of alarm or trip, Its code is displayed.
• Display of alarm/trip information:
In case of alarm or trip, Its information is displayed.
Functions of function keys
: Switches between Quick mode and Standard Setting mode.
: Goes to the Language selection window.
3.3.1 Setting a panel operation frequency
Only when Frequency input mode selection 1 (parameter “FMOd”) is set at “4”, panel operation frequency setting is
activated.
1. Press the control dial.
The panel frequency window appears.
The current operation frequency setting is displayed at the center
of the window.
The current output frequency is displayed in the upper right section
of the window.
The minimum allowable frequency (min) and the maximum
allowable frequency (max) are displayed at the bottom of the
window.
Functions of function keys
The functions keys allow you to select the position or decimal place
of each figure (operation frequency) you want to increment or
decrement with the control dial.
: Selects the position of 1000 times of minimum setting unit.
: Selects the position of 100 times of minimum setting unit.
: Selects the position of 10 times of minimum setting unit.
: Selects the position of minimum setting unit (In this case, 0.1).
F1
F2
F1
F2
F3
F4
To
p
View Mode
FWD 60.0 Hz RUN
60.0 Hz
Overheat alarm
Lng
Quick
---
Display of commands
executed
Display of
operating status
Display of output frequency
Display of alarm/trip
Display of alarm/trip
message
F1 F2
Basic Parameters
FC
×100 ×1000 ×10 ×1
Output frequency
0.0Hz
0.0Hz
min=0.0 max=60.0
Panel frequenc
y
F1 F2 F3 F4