Filter
Top Products
E6581429
C-4
3
2. After selecting the position of a figure you want to change, specify/confirm a
value with the control dial.
(In this example, 30.0Hz is specified.)
Functions of function keys
The functions keys allow you to select the position or decimal place
of each figure (operation frequency) you want to increment or
decrement with the control dial.
: Selects the position of 1000 times of minimum setting unit.
: Selects the position of 100 times of minimum setting unit.
: Selects the position of 10 times of minimum setting unit.
: Selects the position of minimum setting unit (In this case, 0.1).
When you confirm the value specified, the screen goes back to the top window of Top View Mode.
Q To change the frequency during operation
Press the control dial during operation to display the operation panel operation frequency menu and turn the control
dial to change the setting.
3.3.2 Using an EASY key function
The [F1] function key can be used as a substitute for the EASY key described in the manual E6581386 5.22. The
name of the function assigned to the [F1] key is displayed in the lower left corner of the window, and the [F1] key can
be used as the EASY key.
“Quick” : Quick mode / standard setting mode switching
(F750=0)
“Loc/Rem” : Local / Remote key (F750=2)
“Update” : Monitor peak / minimum hold trigger (F750=3)
* Shortcut key function (F750=1) cannot be used. Even if the
parameter is set so, the name of the function is not displayed
on the screen.
(1) Quick mode / standard setting mode switching function
<Standard Setting mode is selected at power on (parameter PSEL=0)>
• When power is turned on, ”Quick” is displayed. ([F1] key is in OFF State)
In this case, top window of Parameter Setup Mode is ordinary one.
• If the [F1] key is pressed while “Quick” is displayed, it turns to highlighted “ Quick ”. ([F1] key is in ON State)
In this case, the Quick mode window appears as the top window of Parameter Setup Mode.
<Quick mode is selected at power on (parameter PSEL=1)>
• When power is turned on, highlighted “ Quick ” is displayed. ([F1] key is in OFF State)
In this case, the Quick mode window appears as the top window of Parameter Setup Mode.
• If the [F1] key is pressed while “ Quick ” is displayed, it turns to normal “Quick”. ([F1] key is in ON State)
In this case, top window of Parameter Setup Mode is ordinary one.
<Always Quick mode (parameter PSEL=2)>
• Highlighted “ Quick ” is displayed.
The Quick mode window appears as the top window of Parameter Setup Mode.
* In this case, [F1] key is not active.
Basic Parameters
FC
×1000
×10
×1
Output frequency 0.0Hz
30.0Hz
min=0.0 max=60.0
Panel fre
q
uenc
y
×100
F1 F2 F3 F4
F1
F2
F3
F4
Quick
Loc/Rem
Update
Top View Mode
FWD 60.0 Hz STOP
0.0 Hz
Lng
Quick
---