975-0082-01-01 1
Introduction
Function The Xanbus AGS continuously monitors battery voltage and
starts, or stops, the generator when battery voltage drops below or exceeds
the preset limits. It also starts the generator to assist the system’s inverter/
charger when output power demands are high.
Start and Stop Triggers The Xanbus AGS requires a source of start and
stop triggers for automatic operation. The Xanbus AGS monitors the
Xanbus network and starts or stops the generator based on the preset limits
programmed into it.
IMPORTANT:
The Xanbus Automatic Generator Start (AGS) is designed
for use in a Xanbus-enabled Freedom SW Power System only.
The Xanbus AGS requires the additional use of a Xanbus System Control
Panel (SCP) for configuration and monitoring. For details see "System
Requirements".
Figure 1
Xanbus Automatic Generator Start (AGS) Basic Function
Xanbus System Control Panel
Xanbus Automatic Generator Start
System Control Panel
network terminator network terminator
Automatic Generator Start
Freedom Sequence
Freedom SW Inverter/Charger
FREEDOM SW 3012
FREEDOM SW 3012
I
nv
e
r
t
er
Reset Enable
I
nve
r
ter A
C/
On
C
ha
r
ge Fault
Generator
Shore
Power
AC Loads
AC Panel
BATTERY
Inverter
Load Panel
