Filter
Top Products
70 Xanbus Automatic Generator Start (AGS) Owner’s Guide
Troubleshooting
Warning Reference Table
Table 6
AGS Warning Messages
Warning
Number
Message Self-clearing? Cause Action
W200 Generator
was stopped
manually.
No Generator was stopped
by an external Manual
Off switch.
Acknowledge the
warning. To resume
automatic starts and
stops, change the AGS
mode to [Automatic].
W201 Generator
was started
manually.
No Generator was started
by an external Manual
On switch
Acknowledge the
warning. To resume
automatic starts and
stops, change the AGS
mode to [Automatic].
W202 Unable to
start
generator.
AGS will try
again.
Yes The AGS tried, but
could not start the
generator.
No action required. The
AGS will try to start the
generator again until it
reaches the maximum
number of start tries.
W203 Manual Off:
Max
generator run
time reached.
Reset
GenMode.
No The generator has run
for its maximum
allowable time. The
AGS has stopped the
generator and changed
the GenMode to
[ManualOff].
Acknowledge the
warning. Return the
AGS to the desired
GenMode [Automatic
or ManualOn]. Ensure
generator has fuel and
is supplying the
required power for
battery charging and
loads.
W205 Generator
started by its
switch. Use
its switch to
stop.
Yes The generator was
started, but not by the
AGS.
Check your generator.
Stop it using the switch
or control panel on the
generator.
W206 Mismatched
triggers.
Enable stop
trigger or
disable start
trigger.
No You have set a start
trigger, but not a
corresponding stop
trigger.
Acknowledge warning
and set a stop trigger.
W207 Mismatched
triggers.
Enable start
trigger or
disable stop
trigger.
No You have set a stop
trigger, but not a
corresponding start
trigger.
Acknowledge warning
and set a start trigger.
W208 Automatic
start and stop
triggers not
enabled.
Configure
triggers.
No You are attempting to
enter Automatic Mode
without setting triggers.
Acknowledge warning
and set start and stop
triggers.
Table 6
AGS Warning Messages (Continued)
Warning
Number
Message Self-clearing? Cause Action