Filter
Top Products
12-5
12.6 Clearing Memories
The memory, which stores marks, tracks and
initial settings, can be cleared to start afresh.
When this done all default settings are re-
stored.
1. Press the [MENU] key followed by the soft
keys CONFIGURATION and SYSTEM
MENU.
2. Press the soft key MEMORY/TRIP
CLEAR to open the clear memory menu.
DGPS 3D
RETURN
CLEAR
MEMORY
EDIT
CLEAR PLOTTER MEMORY
CLEAR GPS MEMORY
CLEAR ALL MEMORY
TRIP METER CLEAR
NO
NO
NO
NO
s
Figure 12-8 Clear memory menu
3. Press ▲ or ▼ to select memory/trip to
clear.
4. Press the soft key EDIT.
5. Press ▲ to select YES.
6. Press the soft key ENTER or the [ENTER]
key to clear memory selected.
Note: For PLOTTER MEMORY and CLEAR
ALL MEMORY, all waypoints and routes are
cleared and default settings are restored. If
you require this data, save it to a PC.
Remote controller test
This test checks the controls of the remote
controller for proper operation.
1. Press the [MENU] key followed by the soft
keys CONFIGURATION, SYSTEM
MENU and SELF TEST to display the self
test menu.
2. Press the soft key REMOTE CONTROL-
LER TEST to display the screen for test-
ing the remote controller.
REMOTE
TEST
RETURN
PRESS
"CLEAR" KEY
3 TIMES
TO RETURN.
Figure 12-7 Remote controller test
3. Press the any key. The pressed key’s on-
screen location turns black if the key is
functioning properly.
4. To escape, press the soft key RETURN
on the display unit, or press the [CLEAR]
key three times on the remote controller.