Filter
Top Products
45
NOTE: To get the full benefit of the Simulator, it is important to select Simulator manually from the
Start-Up Options menu as opposed to letting the Fishing System enter Simulator automatically (as
it will if a transducer is not connected and you do nothing during power up). Manually selecting
Simulator from the Start-Up Options menu allows you to pre-configure your 700 Series™ Fishing
System for on the water operation. Any menu changes you make will be saved for later use.
A message will appear on the display periodically to remind you that you are using the Simulator.
Exit the Simulator by powering your Fishing System off.
System Status
Use System Status to view system connections and to conduct a unit self-test.
The following screens are displayed in turn when you press the VIEW button when using System
Status:
• Self Test
• Accessory Test
• GPS Diagnostic View (with optional-purchase GPS receiver).
Exit System Status by powering your Fishing System off.
Self Test
Self Test displays results from the internal diagnostic self
test, including unit serial number, Printed Circuit Board
(PCB) serial number, software revision, total hours of
operation and the input voltage.
System Status Self Test Screen