Filter
Top Products
40 ST1000 Plus & ST2000 Plus Tiller Pilots - Owner’s Handbook
4 Installing the Tiller Pilot
Tiller brackets
If the tiller is higher or lower than the mounting socket, you can use a
Raymarine tiller bracket to vary the tiller pin offset so the pilot is
horizontal.
Identifying the correct tiller bracket
1. Clamp the tiller on the boat’s center line.
2. Measure dimension D (if the pushrod is above the tiller) or
dimension E (if the pushrod is below the tiller).
3. Select the appropriate bracket from the following table:
Dimension D
(pushrod below tiller)
Dimension E
(pushrod above tiller)
Bracket
part no.
25 mm (1 in) 51 mm (2 in) D009
51 mm (2 in) 76 mm (3 in) D010
76 mm (3 in) 102 mm (4 in) D011
102 mm (4 in) 127 mm (5 in) D159
127 mm (5 in) 152 mm (6 in) D160
D3194-2
D
81130_3.book Page 40 Wednesday, July 25, 2001 11:57 AM