Filter
Top Products
46 ST1000 Plus & ST2000 Plus Tiller Pilots - Owner’s Handbook
4 Installing the Tiller Pilot
4. Remove the template.
5. Pass the power cable and any other cables (SeaTalk and NMEA)
through the bulkhead and the gasket.
6. Use a small flat-bladed screwdriver to connect the cable(s) to the
socket – refer to the illustrations on the following pages.
7. Assemble the rubber cap to one of the 4 self-tapping screws.
8. Secure the socket to the bulkhead using the 4 self-tapping screws.
9. Secure the cable(s) at regular intervals using suitable clips.
10. Assemble the plug to the socket by screwing the ‘floating’ nut
onto the threaded part of the socket by hand.
11. The retaining ring is designed as a stop for the plug nut to prevent
accidental disassembly. After you have tightened the floating nut,
slide the retaining ring back up the plug to retain the nut.
Power supply
D3297-2
D3265-2
Supply (0 V)
Supply (+12 V DC)12 A fuse
Socket
81130_3.book Page 46 Wednesday, July 25, 2001 11:57 AM