Raymarine ST1000 Plus & ST2000 Plus Marine Instruments User Manual


 
Chapter 1: Introduction 3
1 Introduction
1.3 About this handbook
Part 1: Using the Tiller Pilot
This part of the handbook explains how to use your tiller pilot:
Part 2: Installing the Tiller Pilot
This part of the handbook explains how to install your tiller pilot:
Note: This handbook contains important information about
installing, using and maintaining your new Raymarine product. To
get the best from the product, please read this handbook thoroughly.
Important Information
Warranty
To register your new Raymarine product, please take a few minutes to
fill out the warranty card. It is important that you complete the owner
information and return the card to us to receive full warranty benefits.
Handbook information
To the best of our knowledge, the information in this handbook was
correct when it went to press. However, Raymarine cannot accept
liability for any inaccuracies or omissions it may contain. In addition,
our policy of continuous product improvement may change
specifications without notice. As a result, Raymarine cannot accept
liability for any differences between the product and the handbook.
2
Chapter 2: Using the Tiller Pilot
How to use the tiller pilot.
page 7
3
Chapter 3: Maintenance & Fault Finding
Provides maintenance and fault finding information.
page 27
4
Chapter 4: Installing the Tiller Pilot
How to install your tiller pilot and its components.
page 33
5
Chapter 5: Commissioning the Tiller Pilot
How to check the tiller pilot and perform an initial sea trial.
page 51
6
Chapter 6: Adjusting Tiller Pilot Settings
How to change the tiller pilot calibration settings.
page 61
81130_3.book Page 3 Wednesday, July 25, 2001 11:57 AM