Filter
Top Products
54 ST1000 Plus & ST2000 Plus Tiller Pilots - Owner’s Handbook
5 Commissioning the Tiller Pilot
Checking the wind instrument interface
If you have connected the tiller pilot to a wind instrument, check the
data link as follows:
1. Press
standby and auto together.
2. The tiller pilot should display a
‘W’ followed by the locked
heading.
If the display continues to show a flashing ‘C’ and the current heading,
the tiller pilot is not receiving any wind data. The most likely reason is
a cabling error – either open circuit, short circuit or wires reversed.
Checking the SeaTalk interface
If you have linked the tiller pilot to other instruments or control units
via SeaTalk, check the link as follows:
1. Press
standby.
D3270-2
D3271-2
81130_3.book Page 54 Wednesday, July 25, 2001 11:57 AM