Filter
Top Products
Chapter 6: Adjusting Tiller Pilot Settings 63
6 Adjusting Tiller Pilot Settings
Calibration features
• The number on the left identifies the calibration feature and the
number on the right the currently selected value.
• You can enter the calibration menu to view the existing values
without altering them. After viewing the value, a momentary
press of
standby returns the pilot to its normal operating mode
without affecting the previous settings.
• If the display shows
CAL OFF when you try to enter calibration,
refer to page 66.
Default calibration values
The following table shows the default calibration values. These will
provide safe performance for initial sea trial.
Note: Calibration Levels 2,3,4,7,8 and 12 are not available. If
Calibration Level 10 is set to 0, level 11 will also be omitted.
No. Feature Default setting Adjusted values
1 Rudder gain 5
5Average cruise speed 8
6 Off course alarm angle 20
9 Local magnetic variation Off (– –)
10 North/South turning error
correction
Off (0)
11 Boat’s current latitude 0
13 Rudder damping 3
Calibration feature Value
D167-07a
D214-1
81130_3.book Page 63 Wednesday, July 25, 2001 11:57 AM